- Woman, two teens arrested following narcotics investigation
- Former county officials charged with theft
- New Zion Baptist participates in National Back to Church Sunday Sept. 21
- Donors celebrate new school health center
- Debris cleanup underway near Fordham Dam
- Some good, some bad in Obama executive order on protecting antibiotics
- Two arrested on cannabis charges after search of detached garage on North Henrietta
- Man guilty of drug charges faces 60 years in prison
- Rockford BBB aware of ‘Microsoft’ phone scam
- Judge: Chad Grimm will remain on Illinois governor ballot
New process doubles production of alternative fuel while slashing costs
By Phyllis Picklesimer
Media/Communications Specialist, University of Illinois College of ACES News and Public Affairs
URBANA, Ill. — A new discovery should make the alternative fuel butanol more attractive to the biofuel industry.
University of Illinois scientist Hao Feng has found a way around the bottleneck that has frustrated producers in the past and could significantly reduce the cost of the energy involved in making it as well.
“The first challenge in butanol production is that at a certain concentration the fuel being created becomes toxic to the organism used to make it (Clostridium pasteurianum and other strains), and that toxicity limits the amount of fuel that can be made in one batch,” Feng said. “The second issue is the high energy cost of removing butanol from the fermentation broth at the high concentrations used by the industry. We have solved both problems.”
In the study, funded by the Energy Biosciences Institute, Feng’s team successfully tested the use of a non-ionic surfactant, or co-polymer, to create small structures that capture and hold the butanol molecules.
“This keeps the amount of butanol in the fermentation broth low, so it doesn’t kill the organism and we can continue to produce it,” he said.
This process, called extractive fermentation, increases the amount of butanol produced during fermentation by 100 percent or more.
But that’s only the beginning. Feng’s group then makes use of one of the polymer’s properties — its sensitivity to temperature. When the fermentation process is finished, the scientists heat the solution until a cloud appears and two layers form.
“We use a process called cloud point separation,” he said. “Two phases form, with the second facing the polymer-rich phase. When we remove the second phase, we can recover the butanol, achieving a three- to four-fold reduction in energy use there because we don’t have to remove as much water as in traditional fermentation.”
A bonus is that the co-polymers can be recycled and can be reused at least three times after butanol is extracted, with little effect on phase separation behavior and butanol enrichment ability. After the first recovery, the volume of butanol recovered is slightly lower, but is still at a high concentration, he said.
According to Feng, alternative fuel manufacturers may want to take another look at butanol because it has a number of attractive qualities. Butanol has a 30 percent higher energy content than ethanol, lower vapor pressure, and is less volatile, less flammable and mixes well with gasoline, he noted.
The Energy Biosciences Institute, funded by the energy company BP, is a research collaboration that includes the University of Illinois, the University of California at Berkeley and Lawrence Berkeley National Laboratory. It is dedicated to applying the biological sciences to the challenges of producing sustainable, renewable energy for the world.
“Extractive fermentation with non-ionic surfactants to enhance butanol production” appeared in the May 2012 issue of Biomass & Bioenergy and can be accessed at (http://dx.doi.org/10.1016/j.biombioe.2012.02.007). Co-authors are Feng, Yuanqin Liu and Bin Wang of U of I’s Energy Biosciences Institute (EBI), Pradip B. Dhamole of EBI and India’s Sinhgad College of Engineering, and Zhilong Wang of EBI and China’s Shanghai Jiao Tong University.
From the Sept. 12-18, 2012, issue